With the first batch of units that BIQU released, they provided dual, independent z functionality but never enabled Z_STEPPER_AUTO_ALIGN in the firmware and therefore the production process did not aim to connect the z-steppers in any particular order. NB!!! Checking that my z-steppers are connected the correct way around This should help you to easily identify a sub-heading which you may be particularly interested in or is closely related to a question that you have. The information in this guide is structured so as to cover important usability points or to answer common questions under each sub-heading. Please make sure that you read both as they are equally important. This guide has been written to supplement the information within the main readme under the "Using the firmware on the BX" heading over here. If you ask a question in the facebook group that is covered in this guide I'm going to scowl at you through my monitor and with three mighty waves of my finger declare "tsk, tsk, tsk". If you decide to go ahead and install any of the custom firmware branches on your BX then you must read this guide before using it as it has been carefully written to cover the most common questions that users of the firmware have.
0 Comments
Leave a Reply. |